Chapter 5 Removing and Replacing Miscellaneous Assemblies 147
How to Replace the Fan Tray Assembly
Before You Begin
Complete this task:
■ “How to Avoid Electrostatic Discharge” on page 35
What to Do
1. Position the fan tray approximately 2 inches (5 centimeters) over its location in the
chassis.
2. Make sure the main power and keyswitch/Power button/LED cables are routed
under the right notch on the fan tray assembly.
For information about cable locations, see “About the System Cables” on page 126.
3. Make sure the I/O power cable is routed under the left notch on the fan tray
assembly.
Note – As you lower the fan tray assembly, ensure that the cables remain properly
routed under their notches on the fan tray assembly.
4. Lower the fan tray into place in the chassis.
Align the tabs on the fan tray assembly with the notches on the chassis.
To Next Page
