Chapter 2 Servicing the Main Logic Board and Components 65
What Next
To reassemble the system, complete this task:
■ “How to Replace the System Cover” on page 33
When you are ready to restart the system, be sure to run OpenBoot Diagnostics tests
to verify that the system functions correctly with the new parts you have just
installed. For additional information, see:
■ “About OpenBoot Diagnostics Tests” on page 166
You must also perform a reconfiguration boot so that your system is able to
recognize the new PCI card. For additional information, see:
■ “How to Initiate a Reconfiguration Boot” on page 12
How to Remove a CPU Module
Before You Begin
Complete these tasks:
■ “How to Power Off the System” on page 5
■ “How to Position the System for Service” on page 14
■ “How to Remove the System Cover” on page 30
■ “How to Avoid Electrostatic Discharge” on page 35
■ “How to Remove the Air Guide” on page 79
What to Do
1. Locate the CPU module to be removed from the main logic board.
For information about the CPU module location, see “How to Install a CPU Module”
on page 69.
To Next Page
Loading...
