10 Sun Fire 280R Server Service Manual • January 2001
Note – If you have just installed an internal or external storage device other than an
FC-AL drive or a USB device, or any new part that plugs in to the main logic board,
bring up the system after performing a reconfiguration boot (
boot -r).
The operating system cannot recognize newly added devices or parts until you have
performed a reconfiguration boot. The new boot will add any new devices to the
factory-configured device tree. For more information, see “How to Initiate a
Reconfiguration Boot” on page 12.
For more complete interpretation of the diagnostic output from this procedure,
consult “About Diagnostic Tools” on page 157.
What to Do
Caution – Never move the system when system power is on. Movement can cause
catastrophic disk drive failure. Always power off the system before moving it. For
more information, see “How to Power Off the System” on page 5.
Caution – Before you power on the system, make sure that the top cover and front
doors are properly installed. See “How to Replace the System Cover” on page 33.
To Next Page
Loading...
