Chapter 1 Preparing to Service the System 27
5. Insert the system glides into the inner slides of the rack glides.
Verify that the empty rack slides are completely inside their protective outer glides.
Slide the ball-bearing runner forward as far as it will go in the slide. Slide the
crimped end of each system glide into the corresponding inner slide.
6. Slide the system smoothly into the rack slide until it is stopped inside the rack
enclosure.
Note – The server is not yet fully installed. The flat spring catches on both slide
assemblies will prevent the slide assembly from totally closing as you slide the
server into the rack.
System glide
Inner rack slide
To Next Page
