Chapter 1 Preparing for Installation 3
Optional Components
The standard components of the Sun Fire T1000 server are installed at the factory.
However, if you ordered options such as additional memory or a PCI card, these are
shipped separately. Install these components prior to installing the server in a rack.
If you ordered any other options that are not factory-installed, see the Sun Fire T1000
Server Service Manual for installation instructions.
Note – All internal components must be installed only by qualified service
technicians.
Caution – Electrostatic damage can permanently disable the system or require
repair by Sun service technicians. Place components on an antistatic surface, such as
an antistatic discharge mat, an antistatic bag, or a disposable antistatic mat. Wear an
antistatic grounding strap connected to a metal surface on the chassis when you
work on system components.
Note – The list of optional components can be updated without notice. Refer to the
Sun Store web site (http://store.sun.com) for the most current list of
components supported in the Sun Fire T1000 server.
Installation Overview
This installation guide provides procedures that must be performed in the following
order.
1. Verify that you have received all of the components that ship with your server.
See “Shipping Kit Inventory List” on page 2.
2. Gather configuration information for your system. See your system administrator
for specific details, including these parameters:
■ Netmask
■ IP address for the system controller
■ Gateway IP address
To Next Page
