39
APPENDIX
A
Updating the Sun Fire T1000
Firmware
The flashupdate command updates both the system controller firmware and the
host firmware.
The flash image consists of the following components:
■ System controller firmware
■ OpenBoot
■ POST
■ Reset/Comfit
■ Sequencer
■ Partition description
Updating the Firmware
To use the features and fixes in subsequent firmware releases, perform this update
procedure.
▼ To Update the Firmware
1. Ensure that the SC network management port is configured.
This is required to access the new flash image over the network. See “To Configure
the System Controller Network Management Port” on page 28.
To Next Page
