32 Sun Fire T1000 Server Installation Guide • January 2006
▼ To Log In To the System Controller Using the
Network Management Port
Note – You must configure the system controller parameters shown in “To
Configure the System Controller Network Management Port” on page 28 before you
can use the network management port.
1. Open a Telnet session and connect to the system controller by specifying its
network address.
LOOPBACK - - PASSED
I2C - - PASSED
EPROM - - PASSED
FRU PROM - - PASSED
ETHERNET - - PASSED
MAIN CRC - - PASSED
BOOT CRC - - PASSED
TTYD - - PASSED
TTYC - - PASSED
MEMORY - - PASSED
MPC885 - - PASSED
Please login:
% telnet 129.xxx.xx.xx
Trying 129.xxx.xx.xx...
Connected to 129.xxx.xx.xx.
Escape character is '^]'.
Copyright 2003 Sun Microsystems, Inc. All rights reserved.
Use is subject to license terms.
Sun(tm) Advanced Lights Out Manager 1.0.11 ()
Please login:
To Next Page
Loading...
