Chapter 1 Preparing for Installation 5
Note – The SC network management port is not operational until you configure
network settings for the system controller (through the SC serial management port).
10. Enable the new configuration by resetting the system controller. See “To Reset
the System Controller” on page 31.
11. Power on the server from a keyboard using the ALOM-CMT software. See “To
Initiate the Power On Sequence” on page 33.
12. Configure the Solaris OS. See “To Boot the Solaris Operating System” on page 36.
The Solaris OS is preinstalled on the server. When you power on, you are
automatically guided through the Solaris OS configuration procedure. See “To
Boot the Solaris Operating System” on page 36.
13. Install any required patch or patches to the server.
Refer to the Sun Fire T1000 Server Product Notes for a list of the required patches.
14. Load additional software from the Solaris media kit (optional).
The Solaris media kit (sold separately) includes several CDs containing software
to help you operate, configure, and administer your server. Refer to the
documentation provided with the media kit for a complete listing of included
software and detailed installation instructions.
Slide Rail Assembly Notes
The rackmount kit has two slide rail assemblies. Each slide rail assembly can be
installed on either the right or left side of the rack.
A slide rail assembly consists of three main sections: a front section, a sliding rear
section, and a removable mounting bracket (
FIGURE 1-2). The rackmount kit also
includes two extension brackets.
To Next Page
