Sun Microsystems Sun Fire T1000 - Using the System Controller for Common Operations; To Initiate the Power on Sequence; To Connect to the System Console

Chapter 3 Powering On the System 33
2. Login as admin using the password you previously set.
Using the System Controller for
Common Operations
▼ To Initiate the Power On Sequence
Powering on the system requires you to use the poweron command at the SC
console.
● To initiate the power-on sequence, issue the poweron command.
You will see an sc> alert message on the system console. This indicates that the
system has reset.
▼ To Connect to the System Console
Output from POST, OpenBoot, and the Solaris OS is displayed in the system console
using the network console on the system controller.
● Execute the console command, and use the –f option to force the console to be
attached to your session.
Multiple users can be connected to the console, but only one can be attached.
Please login: admin
Please Enter password: password
sc>
sc> poweron
SC Alert: Host System has Reset
sc>
sc> console –f
#. (Enter #. to return to ALOM)