40 Sun Fire T1000 Server Installation Guide • January 2006
2. Open a Telnet session and connect to the system controller, as in the following
example.
3. Login as admin, using the password you defined during the configuration of the
system controller.
4. Execute the flashupdate command.
The flashupdate SC command updates the system controller flash image and the
host firmware. The flashupdate command requires the following information:
■ IP address of a system on the network that can access the flash image.
■ Full path name to the flash image that the IP address can access.
■ Username and password of an account registered on the system that is specified
by the IP address.
The command usage is as follows:
flashupdate [-s IPaddr -f pathname] [-v]
where:
■ -s IPaddr is the IP address of any system on the network that can access the flash
image
■ -f pathname is the full path name to the flash image
■ -v is the flag to turn on verbose message output
% alternate xxx.xxx.xx.xx
Trying xxx.xxx.xx.xx...
Connected to xxx.xxx.xx.xx.
Escape character is’^]’.
Use is subject to license terms.
Symptom) Advanced Lights Out Manager 1.0.11 ()
Please login:
Please login: admin
Please Enter password: password
sc>
sc> flashupdate -s xxx.xxx.xx.xx -f pathname
Username: username
Password: password
............................................................... .
Update complete. Reset device to use new image.
sc>
To Next Page
