2 Sun Fire V890 Server Rackmounting Guide • May 2004
Check the list in the following section to make sure that you received the complete
kit. Contact Sun Microsystems or your distributor/reseller if any parts are missing.
Inventory
You will need one rackmounting kit for each Sun Fire V890 server you intend to
install into a cabinet. Each rackmounting kit contains the following parts:
■ Tray assembly
■ Cable management bracket for the server (EIA-compliant rack kit only)
■ Cable management bracket for the cabinet (EIA-compliant rack kit only)
■ Short rear brackets (2) (EIA-compliant rack kit only; in a bag labeled 560-2682-01)
■ Power jumper cords (3)
■ Lifting handles (4)
■ Trim strips (2)
■ Tie wraps
■ Screws
■ Sun Fire V890 Server Rackmounting Guide (this document)
To Next Page
Loading...
