Sun Microsystems Sun Fire V890 Rack Mounting Guide

5
CHAPTER
2
Installing the Server Into a 19-Inch
Cabinet
This chapter provides step-by-step instructions for installing the Sun Fire V890
server into a 19-inch (48.26-cm) wide EIA-compliant cabinet.
To install a Sun Fire V890 server into the cabinet, complete the following tasks in the
order listed:
■ Make sure you have completed the prerequisite tasks. See “Before You Begin” on
page 6.
■ Prepare the server. See “Preparing the Server” on page 8.
■ Prepare the cabinet. See “Preparing the Cabinet” on page 18.
■ Install the tray assembly into the cabinet. See “Installing the Tray Assembly Into
the Cabinet” on page 18.
■ Install the server into the tray assembly. See “Installing the Server Into the Tray
Assembly” on page 23.
■ Make the server ready for operation. See “Restoring the Server” on page 28.
■ Secure the tray handle to the cabinet rails. See “Securing the Server in the
Cabinet” on page 28.
■ Install the trim strips. See “Installing Trim Strips” on page 30.
■ Replace the front and back doors of the cabinet. See “Restoring the Cabinet” on
page 30.
■ Develop the cable management scheme. See “Managing Cables” on page 31.

Sun Microsystems Sun Fire V890 Specifications

General

Brand	Sun Microsystems
Model	Sun Fire V890
Category	Server
Language	English