Sun Microsystems Sun Fire V890 Rack Mounting Guide

1
CHAPTER
1
Getting Started
This guide shows you how to install the Sun Fire V890 server into a rack or cabinet.
After you install the server into the cabinet according to the instructions in this
guide, see the Sun Fire V890 Server Owner’s Guide for information about system setup
and software installation.
To install the server into a cabinet, complete the following tasks:
■ Unpack and verify the contents of the rackmounting kit. See “Unpacking the Kit”
on page 1 and “Inventory” on page 2.
■ Install the server into the cabinet.
■ To install the server into an Electronic Industries Association (EIA)-compliant
19-inch (48.26-cm) wide cabinet, see Chapter 2.
■ To install the server into a Sun Rack 900 cabinet, see Chapter 3.
■ To install the server into a 31.5-inch (80-cm) cabinet, such as the Sun Fire
Expansion Cabinet, see Chapter 4.
Note – To illustrate the procedures, this guide shows the server being installed into
a Sun Microsystems
TM
cabinet.
Unpacking the Kit
The rackmounting kit is shipped from the factory in one carton.
Inspect the shipping carton for physical damage. If the carton is damaged, request
that the carrier’s agent be present when the carton is opened. Keep all contents and
packing material for the agent’s inspection.

Sun Microsystems Sun Fire V890 Specifications

General

Brand	Sun Microsystems
Model	Sun Fire V890
Category	Server
Language	English