14 Sun Fire V890 Server Rackmounting Guide • May 2004
2. Remove the lower side panel from the left side of the server.
Remove the screw located approximately 3 inches (8 cm) from the front of the lower
side panel.
Note – On the left side of the server, do not remove the screw that attaches the small
bracket to the side of the server. Removing this screw prevents the front door from
closing securely.
3. Grasp the trim strip and slide the lower side panel toward the rear of the server.
The lower side panel should disengage as you slide the panel so that you can easily
remove it.
Do not remove this screw.
To Next Page
Loading...
Need help?
General
