Chapter 2 Installing the Server Into a 19-Inch Cabinet 27
7. Secure the server to the tray assembly using the eight M4 screws you removed in
Step 5.
Use four M4 screws on each side of the server as shown in the following figure.
Do not tighten the screws until all screws are in place and you check the placement
of the server.
8. Check that the server is level and centered on the tray.
Use a level and adjust the server position if necessary.
9. Tighten the eight M4 screws that secure the server to the tray assembly.
Tray
Tray
To Next Page
Loading...
