8 Web Interface User Manual
38
Step 2 Click "Setting" to set initial parameters for the single device.
Batch setting:
Step 1 Select the desired country (region) and grid type.
Step 2 Click "Configure synchronization".
Step 3 Select the desired devices in the pop-up device list, and click "Save" to
achieve batch setting.
8.7.4 Protection Parameter
Click "Device monitoring" -> "Protection parameter" to enter the corresponding
interface and set protection parameters.
Protection parameters can be set in two manners: single setting and batch setting.
For specific setting method, refer to “8.7.3 Initial Parameter".
8.7.5 General Parameter
Step 1 Click "Device monitoring" -> "General parameters" to enter the
corresponding interface and set general parameters.
Step 2 Select "Read-back", set register address, register number, and address type,
and click the button "Read-back", to read the current value of the device.
Step 3 Select "Setting", set register address, data type, and set value, and click the
button "Save", to set device parameters.
8.7.6 Device Instruction
Click "Device monitoring" -> "Device instruction" to enter the corresponding
interface.
On this interface, users can boot/shutdown the device or reset all settings.
Device instruction can be set in two manners: single setting and batch setting. Take
the boot operation as an example for explanation.
Single setting
Step 1 Select a device, click “boot”, and a dialog box pops up.
Step 2 Click “Yes” to start a single device.
Batch setting
Step 1 Select a device, click “boot”, and a dialog box pops up.
Step 2 Click "Configure synchronization".
To Next Page
Loading...
