Sungrow EMS300 - Active Power Control; Fixed Value

15
PPaarraammeetteerrss
DDeessccrriippttiioonn
LLooccaall//RReemmoottee
Local
Set Value (kV) Set a fixed value locally for control
Remote
Receive the fixed value issued by
AGC for voltage control
SSllooppee CCoonnttrrooll
Commissi-
oning
Rising Gradient
(%Un/min)
Control the gradient of voltage
rising
Falling
Gradient (%Un/
min)
Control the gradient of voltage
falling
Ceasing
—
CCoonnttrrooll DDeeaadd
ZZoonnee ((kkVV))
Default value 1.000
Set the value according to actual
situation
GGrriidd NNoommiinnaall
VVoollttaaggee ((kkVV))
Default value 0.000
Set the value according to actual
situation
When setting the llooccaall//rreemmoottee status, it must be consistent with the llooccaall//
rreemmoottee status of the plant lumped parameter, otherwise the policy will not be
executed.
-- -- EEnndd
6.4 Active Power Control
6.4.1 Fixed Value
Active fixed power control: Control the plant to output active power at the target value.
step 1 Click CCoonnttrrooll MMeetthhoodd→→AAccttiivvee PPoowweerr CCoonnttrrooll→→FFiixxeedd VVaalluuee to enter the
corresponding interface.
step 2 Click
to set the status of the FFuunnccttiioonn CCoommmmiissssiioonniinngg//CCeeaassiinngg, LLooccaall//RReemmoottee
and to set the parameter values forSSeett VVaalluueeand CCoonnttrrooll DDeeaadd ZZoonnee.
User Manual 6 Control Method