20
• Remove all obstacles that exist or may exist on the way, such as tree branches, cables,
etc.
• The ESS should be transported and moved under good weather conditions.
• Be sure to set up warning signs or warning area to prevent non-staff from entering the
lifting area to avoid accidents.
• When transporting by road, it is important to use ropes to secure the top ring of the
equipment to the transport vehicle to avoid excessive tilt during transportation.
3.4 Storage Requirements
• To prevent possible condensation or its bottom from being soaked by rain water in the
rainy season. The ESS should be stored on higher ground.
• Raise the container base due to site conditions. The specific height should be
reasonably determined based on site geological and meteorological conditions.
• Store the ESS on a dry, flat, and stable ground with sufficient carrying capacity and
without any vegetation cover. The ground must be flat and dry.
• Before storage, ensure that the doors of the container and all internal equipment are
locked.
• Storage environment temperature: -30 ℃ ~ 60 ℃, recommended storage temperature:
-30 ℃ ~ 25 ℃.
The battery attenuation coefficients at other temperatures are listed below.
Temperature range
Attenuation coefficient
26 ℃ ~ 40 ℃ 0.1 %/month
41 ℃ ~ 50 ℃ 0.3 %/month
51 ℃ ~ 60 ℃ 0.6 %/month
• Long-term storage of batteries is not recommended because it may cause the decrease
in battery capacity. Even if the battery is stored at the recommended storage
temperature, irreversible capacity fade will still occur during periods of rest. The longer it
has been stored, the greater the capacity fade. Please refer to the technical protocol for
specific rate of capacity fade.
• The relative humidity should be between 0~95%, without condensation.
• The air inlet and outlet of the ESS should be effectively protected to prevent rain water,
sand and dust from penetrating into the container.
• Carry out periodic inspections. Check the container and the inner equipment for damage
at least every half a month.
• Before installing a container that has been stored for more than six months, open the
door to visually check and ensure that there is no condensation. Check the container
and the inner equipment for damage. Check the product after it is powered on and starts.
If necessary, request professionals for testing before installation.
3 Transport and Storage System Manual
To Next Page
Loading...
