7
Lethal voltages are present inside the device!
• Pay attention and follow the warning signs on the device.
• Respect all safety instructions in this manual and other pertinent documents.
Electric shock or fire may occur due to the device damage or system fault.
• Visually inspect for device damages or other hazards.
• Check if the external devices and circuit connections are safe.
• Only operate the device when it is safe to do so.
The equipment shall be dried after passing through condensing environment, and
it is recommended to dry it under ventilation for at least 24 hours.
Before running the equipment, insulation resistance test shall be performed, and
then withstand voltage test after the insulation resistance test is passed:
• When all the tests pass, the running operation can be continued.
• If the insulation and withstand voltage test fail, it is required to continue to dry
until the requirements are met.
Generally, the equipment can run normally after 2 rounds of drying.
All installations and operations on the station must be in full accordance to the na-
tional and local regulations and standards.
2.2.2 Manual Storage
Product manuals are indispensable part of the product. Very important information about the
transport, installation, maintenance and troubleshooting of the PCS is included in this man-
ual. All the descriptions in this manual, especially those safety-related items, must be com-
plied with. Please read all the instructions thoroughly prior to any operation work on the PCS.
• Transport, install, maintain and service the PCS by strictly following the descriptions in
this manual. Device damage, personal injury or property loss may follow if otherwise.
• This manual and relevant documents should be available for relevant persons at all
times.
System Manual 2 Safety Instructions
To Next Page
Loading...
Need help?
General
