108
8) Adjusting Parts for the Wiper
A. Adjustment method of wiper location
ⓐ When height of needle end on needle plate is 19.5mm, unscrew wiper crank joint screw.
ⓑ After pressing wiper rolling link ③, adjust wiper shaft ④ that the next wiper and needle get
separated about 10mm.
ⓒ Fasten wiper crank joint screw ②.
ⓓ After adjusting the gap between wiper bottom and needle end becomes about 1mm by unfastening
wiper joint screw ⑤, fasten wiper joint screw tightly.
B. Wiper on/off switch
If you want to use the wiper, press the Wiper
On/Off Switch —, if you don’t, press the
Wiper Operating Switch
O
.
[ Caution ]
If the wiper is not placed in the right position, the wiper may collide with the presser foot or needle
during the operation, and the wiper may not move properly.
To Next Page
Loading...
