D. Press ESC key to back to the general sewing
mode.
NO:000 NOR_SEW
XS:100%
YS:100% SP:1500
BC:000 PC:0000
F. When update is finished, you can see the screen
like a figure on the right side. By rebooting
after turning off the power. The system program
is updated completely.
E. If you press any key the system program is
updated through a floppy diskette. During
updating, READY LED flicker.
※ Caution
During reading a floppy disk, do not take out the
floppy disk from a disk drive or do not turn off
the main power.
D. You can see the screen like a figure on the right
side.
C. Move to “2. Sys. Update”by using direction keys
, then press ENTER key.
A. Insert a floppy disk having system program that
you want to update into a floppy disk drive.
B.
After pressing MODE key, press ENTER key.
※ Caution
In case READY LED is turned on or upper feed
plate is under, some keys are not available. So
you have to operate the keys after lifting the
upper feed plate or pressing ENTER keys.
<< Main Menu >>
0. Initialize
1. Parameter Set
2. Program
<< Initialize >>
2. Sys. UpDate
Insert System
Disk...
Press Any Key
To Continue...
Updating......-
System Updated!
Power Off & On!
To Restart.....
13) System Program Update
It is used that you want to updata the existing version of system program to the latest one.
※ Caution
Please do not handle it without operating by professional A/S engineer.
To Next Page
Loading...
