D.
Input the time for repeating Jump and transfer
distance of XY, then press ENTER key. If
you want to test with the factory-installed
setting value, just press ENTER key.
E.
If you want to finish test menu, press ESC key.
F.
Back to the initial screen by pressing ESC key.
X-Y Jump Test
Delay:0007[ms]
jmp_dx:0020
jmp_dy:0020
2) It is Able to Convert from Embroidery Design
Enable embroidery work by converting embroidery design into pattern program. After reading in SST type
of SWF and DST type of TAJIMA, convert into pattern type and store it on the floppy diskette. Then
perform embroidery work by calling the converted pattern type.
A. Insert the floppy diskette with the embroidery
design into floppy disk driver.
B. Press MODE key.
C. Move to “6. EMB. Call”menu by using the
direction key .
D. Pressing ENTER key, the right screen shall
appear and preparation lamp (READY LED)
shall flicker. If embroidery design is SST type of
SWF embroidery machine, press ‘0’and if it is
DST type of TAJIMA, press ‘1’.
E. After selecting desired design by using direction
key , press ENTER key.
F. After input the pattern number to store, press
ENTER key.
(For example, in order to store the pattern no
200, input [2][0][0].)
<< Main Menu >>
6. EMB Call
Insert Disk
SWF(0)/TAJIMA(1)
To Exit(ESC)...
<< File List >>
JS-GO.SST <-
JSSTRW.SST
Enter Number to
be stored
NO:200
To Next Page
Loading...
