2) Program Example 1 : Generating the Square Pattern
(0,0)
Move
3mm
→
→
JUMP
P1
P4
P2
P3
(-650,-300) (650,-300)
(-650,300)
(650,300)
A. Insert a floppy disk into a floppy disk drive.
B. Press MODE key.
C. Move to “2. Program”by using direction keys
, then press ENTER key. At this time,
the upper feed plate comes to descend and
needle returns to its initial position.
D. After pressing JUMP key, move to the initial
point of square by using direction keys. Then,
press PNT SET key.
E.
If you press EXE key, the machine operates pattern
data, then the feed plate moves according to the
operated data.
F
.
After pressing LINE key, input the stitch lenght
by using the digit keys, then press ENTER
key. (For example, if you want to set the
stitch length as 3mm, input [0][3][0].)
<< Main Menu >>
2. Program
3. Bobbin Wind
4. Machine Test
ORIGIN
X:00000A N:00000
Y:00000A
Function Code?
JUMP NONE
X:-0650A N:00065
Y:00300A
Function Code?
007:LINE
WIDTH:030[0.1mm]
004:JUMP
X:-0650
Y:00300
N:001
To Next Page
Loading...
