17
[ Fig. 11 ]
D. Open the hook cover and supply oil till the
shuttle race ring is surrounded by oil. Put the
hook cover back on after finishing.
E. Supply sillicon oil into the sillicon oil tank
which is installed on the right side of the arm.
Unfasten the needle fixing screw on the needle bar.
Then, with the needle groove facing forward, push
the needle until the upper end touches the needle
hole of the needle bar. Fix the needle in with the
needle fixing screw.
[ Fig. 12 ]
[ Fig. 13 ]
[ Caution ]
For safety, keep the hook cover covered during
operating.
3) How to Install the Needle Bar
Screw
Needle
To Next Page
Loading...
