16
2) How to Supply Oil
[ Fig. 8 ]
A. Check the amount of oil left in the oil tank
which is installed on the arm and supply oil
sufficiently.
B. After moving the X-frame to “A”direction as
shown in the figure, check the remained oil
through oil check window ① on the table cover
plate and supply enough oil through oil filler ②.
C. Supply oil into the hole in the upper part of the
arm.
[ Fig. 9 ]
[ Fig. 10 ]
[ Caution ]
Be sure to supply oil when operating the machine
for the first time or when the machine has not
been used for a long time.
①
X-Frame
A
②
To Next Page
Loading...
