<< Main Menu >>
2. Program
3. Bobbin Wind
4. Machine Test
M. Complete the program for the rest part of the
square by using LINE.
N. After performing test sewing, store the programmed
pattern with new number.
O. To complete pattern creation, press MODE key.
The upper feed plate moves up after returned to
the origin. Return to the initial screen by pressing
ESC key.
7) Using the Extension/Reduction Modes
It is used when you want to extend or reduce the already programmed sewing patterns, and you should
be careful not to exceed the transfer limit during the setting for rate of extension/reduction. You can
extend or reduce with STITCH_LEN by the stitch width, and with STITCH_NUM by the numbers of
stitches. To use these functions, the parameter number related to general sewing, “053. Setting the magnifying
/demagnifying mode”should be set to “2)STITCH_LEN”or “3)STITCH_NUM”.
(1) Setting the extension/reduction mode
A. Press MODE key.
B. Move to “1. Parameter Set”by using direction
keys .
<< Main Menu >>
1. Parameter Set
2. Program
3. Bobbin Wind
C. If you press ENTER , you can get the
screen
like a figureon the right side, then input
[0][5][3].
※ Appendix :
Refer “Parameter number related to general sewing.”
D. After pressing ENTER key, decide whether
you use extension/reduction or not by using
direction keys .
Here set we “2)STITCH_LEN: Extension/
Reduction by stitch length”.
<Parameter Set>
PARA No : 053
053:Scale MODE
1) DISABLE
2) STITCH_LEN <-
3) STITCH_NUM
To Next Page
Loading...
