70
99
DESCRIPTION ON PARAMETER RELATED TO GENERAL
SEWING OPERATION
※ The shadow area indicates factory-installed condition.
Function No. : 000 Function Name : Manual Operatoin En/Dis
It is to set moving of feed plate manually by using direction keys.
It is impossible for feed plate to move by using direction keys.
[ Contents ] It is impossible to make the feed plate move manually by using direction
keys in the sewing available mode.
[ Caution ] It is possible to make the feed plate move manually by using direction keys
without having relation to setup, under the condition of pattern
programming.
It you set up for “Disable”, you can’t use the Function No 001‘Moving to
start position/the 2nd origin by manual drive’.
000. Jog En/Dis
1) DISABLE
Setting
Value
It is possible to make the feed plate move by using direction keys.
(Factory installed condition)
[ Contents ] It is possible to make the feed plate move manually by using direction keys
in the sewing available mode.
[ Caution ] It is only possible when upper feed plate is down.
2) ENABLE
To Next Page
Loading...
