120
18) Exchanging the Fuse
8 Fuses are used.
No. Quality Use
① 0.5A
For the Protection of thread sensor
② 3A
For the Protection of control power
③ 7A
For the Protection of actuator
④ 8A
For the Protection of step driver
⑤ 0.5A For the Protection of step-aux
⑥
INPUT 110V 7A
For the Protection of main power
INPUT 220V 5A
⑦ 15A For the Protection of servo motor
⑧ 0.5A
For the Protection of servo motor drive
■
To prevent from electrice shook, turn off the power and wait 5 minutes, then open
the cover
■
Be sure to turn off the power and exchange into the fuse of the designated quantity
after opening the cover of control box.
Caution
<Power Board>
<Main shaft Mator Drive Board>
①
②
③
④
⑤
⑥
To Next Page
Loading...
