D. If you don’t know any relevant number, press
ENTER key and then, move to the
parameter number you want by using direction keys
.
※ Appendix :
Refer “Parameter number related to general sewing.”
C. IF you press ENTER key, you can get
the screen like a figure on the right side. If you
know the parameter number related to general
sewing, input the three digit parameter number.
For example, if you want to change “004:Strt
Ret Mod”, input [0][0][4]. At this time, you
should input [0] twice for the first and second
digits.
※ Appendix :
Refer “Parameter number related to general sewing.”
A. Press MODE key.
B. Move to “1. Parameter Set”by using direction
keys .
<< Main Menu >>
1. Parameter Set
2. Program
3. Bobbin Wind
<Parameter Set>
PARA No : 004
<Parameter Set>
004.Strt Ret Mod
005.Bobbin Count
006.Prodct Count
11) Change of Parameter Related to General Sewing
It is used when you want to change the operating system of electrically controlled pattern sewing machine
for optimum working condition.
G. After leaving the programming menu by pressing
MODE key, back to the intial screen by
pressing ESC key.
※ Referring to “Pattern Number Check”, check
the copied pattern number.
F. After copy the READY LED is turned off, if
you want to make a copy the pattern to the
same floppy diskette as another pattern number,
press WRITE key and input the pattern
number that is to be copied by using digit keys.
(For example, input [0]0][2] to make a copy as
“002”.)
To make a copy to other floppy diskette, take
out the existing diskette and insert other floppy
diskette, then press WRITE key input the
pattern number you want to make a copy by
using digit keys.
(For example, input [0]0][1] to make a copy as
of “001”.)
015:PTRN WRITE
NO :002
<< Main Menu >>
2. Program
3. Bobbin Wind
4. Machine Test
To Next Page
Loading...
