22
13) How to Use Pallet
A. Removal of Upper Clamp Device
a) First, turn off the power and cut off influx of
air by turning the finger valve (See Figure 6
on page 14) to counter clockwise direction.
b) Disassemble the hose connected to the left
and right upper clamp cylinder as shown in
the figure.
d) Separate upper clamp device from X-transfer
frame.
[ Caution ]
After disassembly, fix the remained straight
union (①, ②) and hose part not to enter into
driving part in case of X-Y transfer.
[ Caution ]
In case of screw disassembly, if the screw and
washer enter into x-driving part, a material
trouble can occur in operation of the machine.
Please pay attention in disassembling.
[ Fig. 24 ]
c) Unscrew 3 fixing screw③ of Upper Clamp
Device attached to left/right of X-transfer
frame.
[ Fig. 25 ]
[ Fig. 26 ]
This device is divided into 2 types according to clamping method of sewing material.
Generally it is divided into Upper/Lower Clamp Device (See Figure 26) and Pallet Clamp Device (see Figure
28) for cassette work and unless particular order is made at the moment of purchase, Upper/Lower Clamp
Device is attached and shipped out. This chapter describes how to remove Upper/Lower Clamp Device and
how to attach Pallet in case of using pallet being provided in the accessory box.
①
②
③
To Next Page
Loading...
