110
D. Setting the link stopper in place
ⓐ Unfasten the thread trimming drive link
stopperscrew while thread trimming is not
operated and have the thread trimming drive
link and the thread trimming drive link
stopper notch 0.3mm apart from each other.
ⓑ Tighten the screw.
[ Caution ]
If the link stopper is not set in the right position,
thread trimming may not be operated correctly
and the machine may be lock.
C. Setting the thread trimming shaft in place
ⓐ Unfasten the thread trimming drive link screw and the trimming shaft collar screw.
ⓑ Make the thread trimming shaft tip accord with part of the arm.
ⓒ Tighten the screws.
[ Caution ]
If the position is not adjusted appropriately, thread trimming may not be operated correctly or the
machine may be lock.
To Next Page
Loading...
