Calling the pattern : Calling patterns from memory or floppy disks
Bobbin wind
Using the counter : Using the bottom thread counter and quantity control counter
Setting the extension and reduction
Chain sewing : Performing the chain sewing
Setting the parameter related to general sewing
Pattern programming : Generating the pattern that users want
Bobbin wind
Using the counter : Using the bottom thread counter and quantity control counter
Calling the pattern : Calling patterns from memory or floppy disks
SPS/A Series
Mode key
“3. BOBBIN WIND”
Input of initial value of bottom thread counter
Rate for horizontal ext./red.
Rate for vertical ext./red.
Input of initial value with digit keys
Input of initial value with digit keys
Input of pattern no.
with digit keys
Starting by left pedal
Ending by right pedal
Input of setting
value with digit kerys
Input of setting value
with digit kerys
Selection of chain no. Selection of pattern no.
Repeat as much as the chain sewing number
Input of number
with digit keys
Input of number
with digit keys
Reference
Setting the extension and reduction
Chain sewing : Performing the chain sewing
To Next Page
Loading...
