SunStar SPS/A-3020 5030 SERIES - Page 47

47
(4) Saving as New Pattern Number
A. After pressing WRITE key, input the number
you want to save by using digit keys. then press
ENTER key. Save the generated pattern data
in a floppy diskette as a relevant number.
(For example, if you want to save the pattern
number as 550, input [5][5][0].) During saving
the pattern, the READY LED flickers. When a
pattern of same number is in a floppy diskette
and if you want to save another pattern as
same number, press ENTER key. If you want
to save the pattern as another number, press
ESC key and save it as another number.
After finishing saving, the READY LED turns
off, the upper feed plate moves to the origin
again.
B. For finishing pattern generation, press MODE
key. Then the upper feed plate moves to the
origin and ascends. Press ESC key to back to
the initial screen.
ORIGIN
X:00000A N:00000
Y:00000A
Function Code?
015:PTRN WRITE
NO :550
Pattern Exist!
OverWrite?
Y(ENTER)/N(ESC)
ORIGIN
X:00000A N:00000
Y:00000A
Function Code?
<< Main Menu >>
2. Program
3. Bobbin Wind
4. Machine Test
B. By pressing TEST key, complete the test sewing.
The upper feed plate descends and moves to the
origin, then READY LED turns off.