A.
Press MODE key.
B. Move to “4. Machine Test”by using direction keys
, then press ENTER key.
C. Move to “3. Interrupt Test”by using direction
keys
, then press ENTER key.
D. IRQ1 indicates the times that key is pressed, and
IRQ4 shows the times that sychronizer counted.
IRQ5 indicates
the sensing times main power is
off, IRQ7 shows the timer operation were inside
of CPU. At this time, if you press a key or
turn the upper
shaft manually, the relevant value
will be changed.
E.
If you want to finish Interrupt Test, press ESC
key. If you want to finish test menu, press ESC
key also.
F.
Back to the initial screen by pressing ESC key.
<< Main Menu >>
4. Machine Test
5. Pattern List
6. EMB Call
<< Test Menu >>
3.InterruptTest
4.PWM Test
5.LCD Test
IRQ1 : 0000000
IRQ4 : 0000000
IRQ5 : 0000000
IRQ7 : 0000000
(4) Interrupt Test
It is to test if the CPU board is operated properly.
A,
Press MODE key.
B. After move to “4. Machine Test”by using direction
keys
, then press ENTER key.
C. After moving to “4. PWM Test”by using direction
keys
, then press ENTER key.
<< Main Menu >>
4. Machine Test
5. Pattern List
6. EMB Call
<< Test Menu >>
4.PWM Test
5.LCD Test
6.Keyboard Test
(5) PWM Test
It is to test if solenoid is operated properly. Do not handle it except professional A/S engineer.
To Next Page
Loading...
