7
SPS/A-5030 Series is made to sew patterns on fabrics and other similar material for
manufacturing.
Follow the following indications when operating the machine.
ⓐ Read through this manual carefully and completely before operating the machine.
ⓑ Wear the proper clothes for work.
ⓒ Keep hands or other parts of the body away from the machine operation parts
(needle, shuttle, thread take-up lever, and pulley etc.) when the machine is being
operated.
ⓓ Keep the covers and safety plates on the machine during operation.
ⓔ Be sure to connect the earthing conductor.
ⓕ turn off the electric main power and check if the switch is turned “off”before
opening electric boxes such as the control box.
ⓖ Stop the machine before threading the needle or checking after work.
ⓗ Do not step on the pedal when turning the power on.
ⓘ Do not connect several motors to the same concent.
ⓙ If possible, install the machine away from loud noises such as high frequency weld-
ing machines
1-4) Machine
Operation
Warning
Caution
[ Warning ]
Belt will crush or amputate finger or hand, keep cover in place before operating,
turn off power before inspecting or adjusting.
ⓐ Safety label : It describes cautions during operating the machine.
ⓑ Thread take-up cover : It prevents from any contact between body and take-up lever.
ⓒ Belt Cover : It prevents from insertion of hands, feet or clothes by belt.
ⓓ Spool Line Shaft cover : It prevents from any accidents that can occur during shaft
rotation and straight reciprocation.
ⓔ Label for specification of power : It describes cautions for safety to protect against
electric shock during rotating the motors.
ⓕ Finger guard : It prevent from contacts between a finger and needle.
ⓖ Safety plate : It protects eyes against needle breaks.
1-5) Devices for
Safety
ⓑ
ⓐ
ⓖ
ⓕ
ⓔ
ⓒ
ⓓ
To Next Page
Loading...
