SUPERIOR CONTROLS STERLING CONTROLLERS - Misting Cycle Timing; Misting Set Start-of-Cycling Time; Misting Set End-of-Cycling Time

EXAMPLE A: Station 4 to water for 24 seconds, press:
EXAMPLE B: Station 12 to water for 1 minute 40 seconds, press:
To change the watering duration of a station, follow steps a thru d above enter-
ing the new duration at step c To delete a programmed station, enter “0’ at step
c.
Controller will skip unprogrammed stations.
6. Set Start-of- Cycling Time: To set the time that watering will start
(beginning of loop):
a. Press 9 key.
b. Press Cycle Start key.
c. Key in the time of day that watering is to start. If during p.m., the
next step is to press the PM/% key.
d. Press Enter key.
EXAMPLE: If cycling is to begin at 9:00 a.m., press:
7. Set End-of-Cycling Time: To program the time of day that cycling will
stop (end of loop):
a. Press 0 key.
b. Press Cycle Start key.
c Key in time of day watering is to end. If during p.m., the next
step is to press the PM/% key.
d. Press Enter key.
Page
32
4
WED
2
MON
ENTER
4
WED
STA
WATER
TIME
1
SUN
2
MON
4
WED
1
SUN
0
ENTER
STA
WATER
TIME
9 9
0
ENTER
0
CYCLE
START