3-3
Chapter 3: Troubleshooting
3. If the steps indicated above do not x the Setup Conguration problem, con-
tact your vendor for repairs.
Memory Errors
When a No_Memory_Beep_Code is issued by the system, check the following:
1. Make sure that the memory modules are compatible with the system and that
the DIMM modules are properly and fully installed. (For memory compatibility,
refer to the Memory Compatibility Chart posted on our website @ http://www.
supermicro.com.)
2. Check if DIMM modules with different speeds have been installed. It is
strongly recommended that you use the same RAM speed for all DIMMs in
the system.
3. Make sure that you are using the correct type of Registered (RDIMM)/Load
Reduced (LRDIMM)/Non-Volatile (NV-DIMM) ECC DDR4 SDRAM modules as
recommended by the manufacturer.
4. Check for bad DIMM modules or slots by swapping a single module among
all memory slots and check the results.
5. Make sure that all memory modules are fully seated in their slots. Follow the
instructions given in Section 2-4 in Chapter 2.
6. Please follow the instructions given in the DIMM Population tables listed in
Section 2-4 to install your memory modules.
When the System Becomes Unstable
A. When the system becomes unstable during or after OS installation, check
the following:
1. CPU/BIOS support: Make sure that your CPU is supported, and you have the
latest BIOS installed in your system.
2. Memory support: Make sure that the memory modules are supported by test-
ing the modules using memtest86 or a similar utility.
Note: Refer to the product page on our website http:\\www.supermicro.
com for memory and CPU support and updates.
To Next Page