Supero C2G41 - Security Settings

Chapter 4: AMI BIOS
4-19
4-4 Security Settings
The AMI BIOS provides a Supervisor and a User password. If you use both pass-
words, the Supervisor password must be set rst.
Supervisor Password:
This item indicates if a supervisor password has been entered for the system. Clear
means such a password has not been used and Set means a supervisor password
has been entered for the system.
User Password:
This item indicates if a user password has been entered for the system. Clear
means such a password has not been used and Set means a user password has
been entered for the system.
Change Supervisor Password
Select this option and press <Enter> to access the submenu, and then type in a
new Supervisor Password.
User Access Level (Available when Supervisor Password is set as above)
Available options are Full Access: grants full User read and write access to the
Setup Utility, View Only: allows access to the Setup Utility but the elds cannot be
changed, Limited: allows only limited elds to be changed such as Date and Time,
No Access: prevents User access to the Setup Utility.
Change User Password
Select this option and press <Enter> to access the submenu, and then type in a
new User Password.
BIOS SETUP UTILTY
Main Advanced
Security
Boot
Exit
vXX.XX (C) Copyright 1985-2009, American Megatrends, Inc.
Security Settings
Supervisor Password : Installed
User Password : Installed
Change Supervisor Password
User Access Level [Full Access]
Change User Password
Clear User Password
Password Check [Setup]
Boot Sector Virus Protection [Disabled]
Install or Change the
password.
 Select Screen
 Select Item
+- Change Field
Tab Select Field
F1 General Help
F10 Save and Exit
ESC Exit