Sur-Gard System III - Table of Contents

Table of Contents
Section 1 - Introduction .................................... 1
1.1 System Overview ...................................1
1.2 Approvals ..............................................1
1.2.1 Industry Approvals ........................... 1
1.2.2 UL Manual Mode ............................. 1
1.3 Description (Hardware) ..........................2
1.3.1 BP3 Backplane ................................. 2
1.3.2 DC/DC-3 5V Power Converter .......... 2
1.3.3 PSU3 Power Supply Unit .................. 2
1.3.4 PSC3 Power Supply Controller .......... 2
1.3.5 CPM3 Central Processing Module .... 2
1.3.6 DRL3 Line Card ................................ 2
1.3.7 BP3X Interface Module ..................... 3
1.4 Receiver Setup and Operation ................6
1.5 Description (Operation) .........................6
1.5.1 Operation with Default Programming 6
1.5.2 Virtual Connectivity .......................... 6
1.5.3 Status Addressing ............................ 6
1.5.4 Automation Input/Output
(Port 1025) ...................................... 6
1.5.5 Compatibility ................................... 6
1.5.6 Automation Protocols ...................... 6
1.5.7 Data Byte Protocol ........................... 6
1.5.8 Acknowledgment of the Signal ......... 7
1.5.9 COM Responses .............................. 7
1.5.10 Automation Absent ........................ 7
1.5.11 System III SIA Internal Status Output 7
Section 2 - CPM3 Operating Modes .................. 8
2.1 Contrast Adjust ......................................8
2.2 Active Mode ..........................................8
2.3 Manual Mode ........................................8
2.4 Standby Mode .......................................8
2.5 System Trouble ......................................8
Section 3 - DRL3 Operating Modes .................. 9
3.1 DRL3 Standby Mode ..............................9
3.2 Line Fault ...............................................9
3.3 CPM3 Error ............................................9
3.4 Data Reception ......................................9
3.5 Fault Data Message ................................9
3.6 Fault Call Message ..................................9
Section 4 - Programming/Operation .............. 10
4.1 Introduction .........................................10
4.2 System III Console Software .................10
4.3 Debug Programming ............................10
4.3.1 Debug Cable Connectivity .............. 10
4.3.2 Debug Software Setup .................. 10
4.3.3 Downloading Steps ........................ 11
4.4 Manual Programming ..........................11
4.4.1 Advanced Programming ................. 11
4.4.2 System functions ........................... 12
4.5 CPM3 Options .....................................12
Option [01]: IP Address .................................. 12
Option [02]: Subnet Mask Address ................. 12
Option [03]: Gateway Address........................ 12
Option [04]: Auto Update Time & Date........... 12
Option [05]: Contrast Adjust ........................... 12
Option [06]: Password Menu ......................... 12
Option [07]: COM1 Baud Rate ....................... 12
Option [08]: COM1 Data Bits ......................... 12
Option [09]: Parity .......................................... 12
Option [0A]: COM2 Format ............................ 12
Option [0B]: COM2 Baud Rate ....................... 12
OOption [0C]: COM2 Data Bits ..................... 12
Option [0D]: COM2 Parity .............................. 12
Option [0E]: TCP GUI ...................................... 13
Option [0F]: B32 Headers .............................. 13
Option [10]: Input RRLLL Digits ...................... 13
Option [11]: Output RRLLL Digits ................... 13
Option [12]: Heartbeat Timer ......................... 13
Option [13]: Mute Buzzer .............................. 13
Option [14]: Receiver Number ....................... 13
Option [15]: Printer Test ..................................13
Option [16]: Mask PSU 1.................................13
Option [17]: Mask PSU 2.................................13
Option [18]: Mask DC A ..................................13
Option [19]: Mask DC B...................................13
Option [1A]: Mask DC A2 ................................13
Option [1B]: Mask DC B2 ................................13
Option [1C]: Mask Low Battery 1 ....................13
Option [1D]: Mask Low Battery 2 ...................13
Option [1E]: Mask Fan 1 Fail ............................13
Option [1F]: Mask Fan 2 Fail ............................13
Option [20]: Mask UPS AC 1 ..........................13
Option [21]: Mask UPS BAT 1 .........................13
Option [22]: Mask UPS AC 2 ..........................13
Option [23]: Mask UPS BAT 2 .........................13
Option [24]: Mask SG TCP 1 ...........................13
Option [25]: Mask SG Serial 1 .........................13
Option [26]: Mask SG TCP 2 ...........................13
Option [27]: Mask SG Serial 2 .........................13
Option [28]: Mask TCP 1 Printer .....................13
Option [29]: Mask Parallel 1 Printer ................13
Option [2A]:Mask Serial 1 Printer ....................13
Option [2B]: Mask TCP 2 Printer .....................13
Option [2C]: Mask Parallel 2 Printer ................14
Option [2D]: Mask Serial 2 Printer ..................14
Option [2E]: Number of Line Cards..................14
Option [2F]: Automation Mode .......................14
Option [30]: Printer Mode ...............................14
Option [32] Date Format .................................14
Option [33] Protocol ID ...................................14
Option [34] Time Correct.................................14
Option [35] Output Config(Future Use)............14
Option [36] CIS Enable (Future Use) ................14
Option [37] RBUS HighSpeed .........................14
Section 5 - Advanced Programming ............... 17
5.1 Profiles Introduction ............................17
5.2 Static Options: [00] - [2F] ....................18
Option [00]: Reserved .....................................18
Option [01]: Line Card Number ......................18
Option [02]: Line Card Number Length ..........18
Option [03]: Internal messages RS-232 ..........18
Option [04]: 2-Way Audio Activation Time ......18
Option [05]: Pre-H.S. Duration .......................18
Options [06] to [08]: Reserved .......................18
Option [09]: First Ring Length ..........................18
Options [0A] to [0C]: Reserved .......................18
Option [0D]: Ring Select - Default [00] ...........18
Option [0E]: Backup Line Enable/Disable .........18
Option [0F-10]: Reserved ................................19
Option [11]: Hook-flash Enable/Disable ..........19
Option [12]: Caller Source ID Option ..............19
Option [13]: Caller Source to SG Computer ....19
Option [14]: Caller Source to printer ...............19
Options [15]: Reserved ...................................19
Option [16]: Format disabling Option ..............19
Option [17]: DMP User Length .......................19
Option [18]: Sur-Gard DTMF 4/3 Format
Output...........................................19
Option [19]: Fault Call Counter ........................20
Option [1A]: DNIS Input Sensitivity .................20
Option [1B]: Reserved .....................................20
Option [1C]: Busy Out ....................................20
Option [1D]: Reserved ....................................20
Option [1E]: Reserved .....................................20
Option [1F]: Debug Output .............................20
Option [20]: C.L.A.S.S. Field Data ....................20
Option [21] RBUS Speed ................................21
Options [22] - [26]: Internal Use Only ............21
Option [27]: Caller Source Process .................21
Options [28] - [29]: Reserved .........................21
Option [2A]: Hook-flash Delay ........................21
Options [2B] - [2C]: Reserved .........................21
Option [2D]: A.H.S. .........................................21
Options [2E] Reserved ....................................21
Options [2F] Online Time Out .........................21
Dynamic Options: [30] - [FF] .......................... 21
Options [30] - [3F]: 3/1 - 4/1 Digit 0-F ............21
Options [40] - [4F]: 3/2 - 4/2 Digit 0-F ............21
Options [50] - [5F]: 4/3 Digit 0-F ....................22
Options [60] - [6F]: Printer Words ..................22
Option [70]: Automation Common Event
Code............................................. 22
Option [72]: SIA Option .................................. 22
Option [73]: DSP Input and Ouput ................. 23
Option [74]: Equivalent Line Number .............23
Option [75]: Receiver Number ....................... 23
Option [76]: Accounts 3/x to 4/x ..................... 23
Option [77]: Digit Replace ..............................23
Option [78]: Max Inter-digit ............................23
Option [79]: Max Inter-burst ...........................24
Option [7A]: 4 and 5 Digit Account Codes to
Activate 2-Way Audio ...................24
Option [7B]: 3 Digit Account Codes to Activate
2-Way Audio ................................ 24
Option [7C]: Alarm Codes to Activate 2-Way
Audio ...........................................24
Option [7D]: Audio Zone Code ....................... 24
Option [7E] Audio RS-232 .............................. 24
Option [7F]: Audio Format Enable ................... 24
Option 80: Kiss-Off to Hang-up Time .............24
Options [81] through [88]: Handshake
Selection....................................... 25
Option [89] to [90]: Handshake and Kiss-off
Duration .......................................25
Option [91]: Inter-Handshake Duration .......... 25
Option [92]: Reserved ....................................25
Option [93]: Min Audio Tone .......................... 25
Option [94]: Account Digit Stripping ...............25
Option [95]: 5-Digit Pulse ...............................25
Option [96]: 4/1 Extended ..............................26
Option [97]: 4/2 Extended ..............................26
Option [98]: 3/1 Extend .................................. 26
Option [99]: Ademco Express .........................26
Option [9A]: Reserved .................................... 26
Option [9B]: Echo Canceller ............................26
Option [9C]: Acron RS-232 ............................. 26
Option [9D]: MODEM II RS-232 ....................26
Option [9E]: Scantronics Select ...................... 27
Option [9F]: Ademco High Speed RS-232 ......27
Option [A0]: 11 / 12-Digit DTMF (Acron or Scant-
ronics) ..........................................27
Option [A1]: FBI RS-232 .................................27
Option [A2]: Digit Replace ..............................27
Option [A3]: D6500 RS-232 ...........................27
Option [A4]: BFSK RS-232 ..............................27
Option [A5]: Sescoa Super Speed ..................28
Option [A6]: ITI Adjust ....................................28
Option [A7]: Silent Knight FSK2 RS-232 ..........28
Options [A8] - [AF]: Dial-out Number For 2-way
Audio Transfer .............................. 28
Option [B0]: CCITT Audio Format Enable bits.. 29
Option [B1]: DMP Area BIN or DEC Option ...29
Options [B2] - [FF]: Reserved ......................... 28
Glossary .......................................................... 30
Appendix A - Printer Words: Options [60-6F] . 33
Appendix B - System III Internal Status
Messages ........................................................ 35
Appendix C - TELCO Connector Pin-outs ........ 38
Appendix D - DEC-HEX-BIN Conversion Chart . 38
Appendix E - ASCII Character Chart ................ 39
Appendix F - DRL3 Communication Formats ... 40