29
Options A8-AF must be programmed in the following
manner: Digits 1-9 are programmed as the numbers 1-
9. The digit ‘A’ must be programmed if a zero is needed
anywhere in the dial string as the digit zero is used to
indicate to the line card that there are no more digits to
dial. If a '*' is needed, (e.g., *70, the transfer command
in some PBX/PABX switches) program a 'B'. Similarly, if a
'#' is needed, program a 'C'.
To get the line card to wait for 3 seconds in a dial string,
program a 'D'. For example: to have the line card transfer
a 2-way audio call to Ext. 51386, with a 3 second pause
between the transfer command and dialing, Options A8-
AF would be programmed as the following:
Option [B0]: CCITT Audio Format Enable bits - Default [00]
This option is similar to option[7F]. It gives you the ability
to enable and disable audio for the selected CCITT for-
mats. A '1' in the formats bit position will enable the for-
mat for audio. A '0' in the formats bit position will disable
audio for the format.
Bit 0 Robofon Format Bit 4 Telnot format
Bit 1 VONK Format Bit 5 Outel format
Bit 2 Stratel Format Bit 6 Not used
Bit 3 CESA FOrmat Bit 7 Not used
For example: If the user wants audio to work only for
Robofon and Telnot formats, Option [B0] should be pro-
grammed as 11 HEX which enables bit 0 and bit 4.
Option [B1]: DMP Area BIN or DEC Option - Default [00]
This option is similar to the DMP receiver.
00 = Area is sent to the automation in BINARY
01 = Area is sent to the atuomation in DECIMAL
The printer outputs remain unchanged.
Examples: Area is sent to the linecard as C0,
BINARY setting:
Automation:
P01001 20999 L0480TIMAREA 1
P01001 20999 L0440TIMAREA 2
Printer:
00-01-001-20999--Close USR:04 AREA1 TIMAREA 1
00-01-001-20999--Close USR:04 AREA2 TIMAREA 2
DECIMAL setting:
Automation:
P01001 20999 L0401TIMAREA 1
P01001 20999 L0402TIMAREA 2
Printer:
00-01-001-20999--Close USR:04 AREA1 TIMAREA 1
00-01-001-20999--Close USR:04 AREA2 TIMAREA 2
Options [B2] - [FF]: Reserved
1
2
3
The DRL3 has recognized the current call as a
2-way audio account and alarm code.
The calling control panel has finished sending
its alarms and switched into 2-way audio
mode.
The DRL3 will perform a Hook-flash with the
time value as programmed in Option 11 and
then start to dial the digits programmed in
Options A8-AF.
A8 = B7
A9 = AD
AA = 51
AB = 38
AC = 60
AD = 00
AE = 00
AF = 00
To Next Page
Loading...
