Function Settings Feature Introduction
5.3
6 .1
The specific functions that can be set are (By
combining of pulls on the brake lever):
① Low regenerative braking. Operation: 2 short
and 1 long, indicator flashes twice;
② Medium regenerative braking. Operation: 3
short and 1 long, indicator flashes 3 times;
③ High regenerative braking. Operation: 4 short
and 1 long, indicator flashes 4 times;
④ Turn off the regenerative braking. Operation: 7
short and 1 long, indicator flashes 7 times;
⑤ Turn off the side stand switch and tilt switch.
Operation: 6 short and 1 long (automatically
turned on after vehicle powered on again),
indicator flashes 6 times;
⑥ Turn off the brake override. Operation: 8 short
and 1 long, indicator flashes 8 times;
⑦ Turn on the brake override. Operation: 9 short
and 1 long, indicator flashes 9 times;
⑧ Throttle sensitivity setting function. Factory
default is normal mode. Set to pro mode,
A. Rear Brake Lever
When you pull the lever backwards, it will control
the rear brake system.
B. Brake Lever Adjusting Screw
This adjusting screw is used to adjust the span
between the brake lever and the handlebar. The
position of the brake lever is adjusted by using a
2mm Hex wrench to make it more suitable for
individuals.
C. Horn Button
When the main power switch and key switch are in
the ON position, the horn can make a sound
when the horn button is pressed. The Light Bee
electric motorcycle is very quiet when riding, and
the horn can be used to warn pedestrians or other
motorists present.
D. Front Brake Lever
When you pull the lever backwards, it controls the
front braking system.
E. Throttle
The throttle is used to control speed.
Handlebar Controls
operation: 5 short and 1 long, indicator flashes
12 times. To set to normal mode again, opera-
tion: 5 short and 1 long, indicator flashes 11
times. By repeating this operation, you can cycle
through the normal mode and pro mode.
A
B
C
E
B
D
To Next Page
Loading...
