Safety Information Safety Information
2 .1
2.2
Safe Riding Requirements
Before operating a Light Bee electric motorcycle,
make sure you are legally qualified to ride an
electric motorcycle.
Please read and ensure that you are aware of all
warings and instructions as well as safety labels in
this manual before operating the Light Bee electric
motorcycle.
Proper safety gear, including a regional/national
approved helmet, eyewear, riding boots, gloves
and protective clothing should be worn while
riding to reduce the risk of potential injury. We
highly recommend the use of full height moto-
cross boots since the vast majority of motorcycle
injuries are through leg and foot impact.
Please comply with local laws and regulations,
the Light Bee off-road version (X version) is
prohibited from driving on public roads.
Light Bee is a high performance electric motorcy-
cle and should be treated with extreme caution.
Never consume alcohol or drugs before operating
Light Bee electric motorcycle.
Please be responsible for your own riding behav-
ior when operating Light Bee electric motorcycle.
Please do not ride dangerously and recklessly.
Please do not ride in a way that affects the safety
of the public and yourself.
Prior to each use, the rider must check everything
in the " Pre-ride Check"'section on page 7.1 and the
battery level indicated on the battery indicator.
Your safety depends on the good condition of the
Light Bee electric motorcycle. Ensure compliance
with the periodic maintenance table and adiust-
ment requirements contained in this manual.
Make sure you understand the importance of all
items that need to be thoroughly checked before
riding.
Modifying a Light Bee electric motorcycle may
make it unsafe and may cause serious injury.
Surron is not responsible for any unauthorized
modifications.
Do not load heavy objects or add accessories on
the Light Bee electric motorcycle. Large, bulky
items can adversely affect the safety and perfor-
mance of a Light Bee electric motorcycle.
Important Information
Several important operation considerations are
listed below: Always turn the key switch A and
main power switch B to the OFF position when not
actively riding. It is extremely easy to forget that
the motorcycle is still in standby mode because
Light Bee electric motorcycle is completely silent.
An accident can occur if the motorcycle is left
powered up while getting on or off the motorcycle.
Please charge the battery pack of Light Bee
electric motorcycle after each use. Once fully
charged, disconnect from AC power supply.
Disconnect the charger and power supply after
charging. Make sure that charging is done in an
open area or under supervision.
When the key is in the off position and the main
power switch is turned off, the electronics of the
Light Bee electric motorcycle will not consume
power.
If you don't ride for a long time (30 days or more),
you may need to charge the battery pack first to
ensure that it is fully charged.
A
B
The battery pack will be damaged if it is stored
for a long time at a low battery level.
To Next Page
Loading...