Feature Introduction Feature Introduction
6.4
6.5
1. Charger port direction: Charger port B has the
function of preventing misoperation, and the gap
corresponds to battery charging port A for connec-
tion.
2. Charging operation sequence:
①Connect the charger output plug to the battery
socket;
②Connect the charger input plug to the mains
supply;
③After the mains power is powered on, the
charger enters the state of self-test. After the
self-test is passed, it will enter the normal
charging state.
Remove the battery pack. For description and
operation, please refer to page “Battery Pack
Removal” on page 6.2.
Tear the protective film of Battery Bottom Buffer A,
and paste it on the Battery Bottom Positioning
Block B.
Battery Bottom Buffer Installation
3. Connect the Discharge Plug A to the battery
socket.
4. Press the Battery Compartment Cover B to lock it.
1.Put the battery pack in the battery compartment.
2. Verify that the Main Power switch C is in the OFF
position.
Before removal and installation of the
battery pack on the Light Bee motorcycle,
the key switch and the main power
switch must be in OFF position.
When removing and installing the battery
pack, place the discharge plug outside
the left side of the battery compartment.
WARNING
When the battery pack is obviously loose
in the battery compartment, it is recom-
mended to add buffer to avoid the
continuous abnormal noise and damage
to the motorcycle.
CAUTION
B
4
A
B
Charger
B
A
To Next Page
Loading...
