We recommend that you carefully use the
high-pressure water gun to clean the
Light Bee electric motorcycle to avoid
damaging the motorcycle parts.
CAUTION
After cleaning and before starting to ride,
make sure the brakes system function
properly.
WARNING
Maintenance Maintenance
10.15
10.16
Improper cleaning can damage motorcy-
cle parts. Do not use high-pressure water
gun to flush bearings, seals, electrical
components and plugs. In order to extend
the service life of the Light Bee electric
motorcycle, it should be cleaned and
maintained regularly and it is recom-
mended to wipe it dry as soon as possible
after cleaning.
Do not use any harsh chemical products
on plastic parts. Avoid cloths or sponges
that have been in contact with strong
corrosive detergents, solvents, thinners,
fuels (gasoline), rust removers or inhibi-
tors, brake fluid, antifreeze, or electro-
lytes.
CAUTION
Tires only need to be cleaned. Any tire main-
tenance products may reduce the friction
between the tire and the ground, and even
lead to premature aging of the tire.
CAUTION
Do not store the Light Bee electric motorcy-
cle with battery level lower than 20%.
Discharging the battery pack below 20% for
a long period of time may reduce the battery
life or even damage the battery pack.
Battery pack damage due to over-discharge
or long-term very low battery level is not
covered by the warranty.
CAUTION
Wheel and Tire Cleaning
Avoid using strong acid wheel cleaners. If you use
this type of product to clean stubborn dirt, please
clean it in a short time and dry it immediately.
Long-term Storage
For motorcycle that are not used for a long time
(more than 30 days), it is recommended to main-
tain the battery level to about 40% to 50%, and
turn off the main power switch of Light Bee
electric motorcycle.
The battery pack also discharges slowly when
stored. Check the level of the battery pack at least
once every month. If the battery level drops below
20%, then it should be recharged to 40% to 50%.
When you are ready to use the Light Bee electric
motorcycle again, please fully charge the battery
pack to ensure it is restored to its best condition.
In order to extend the service life of the power
system, the Light Bee electric motorcycle should
be stored in a cool and ventilated place. Storing
the Light Bee electric motorcycle in a hot or humid
place will shorten the life span of the battery pack
and electrical system. For more information about
batteries and electrical systems, please refer to
page 8.1.
To Next Page
Loading...
