EasyManua.ls Logo

Surron LIGHT BEE X - Power Management; Battery Pack

Default Icon
51 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The appearance of rear shock may vary in
different brands, please refer to the actual
product.
NOTE
It is NOT recommended to adjust the preload
more than 14mm. Excessive preload will
affect the effective travel of the rear shock.
The damping and preload should be adjust-
ed properly according to the road conditions
and the weight of the rider. Avoid adjusting
the damping to the maximum limit, other-
wise it may cause the rear shock malfunc-
tion or even serious injury.
CAUTION
The Light Bee electric motorcycle uses high-per-
formance and high rated lithium-ion battery
which can be used in the ambient temperature
range of -15 ~ 40°C(5~104℉), the best working
condition is when ambient temperature is
between 10°C ~ 30°C(50~86℉). Extreme low or
high ambient temperature will affect the battery
pack performance and life span. Do not use the
battery pack at temperatures beyond the allow-
able range, and do not charge the battery pack
below 0°C(32℉).
The charging time of the battery pack is about 3
hours in 25°C(77℉) ambient temperature.
When the ambient temperature is too low, the
performance of the battery pack will be affected.
It is normal that the range will be reduced a little,
and the performance of the battery pack will
automatically recover after the temperature rises
back to working condition.
When not in use for a long time, please charge the
battery level to 40% ~ 50%, and check the remain-
ing capacity every month. Charge the battery pack
once when the battery level is less than 20%, so as
to avoid excessive discharge of the battery pack,
affecting performance and causing damage.
It is strictly prohibited to use high pressure water
gun to flush the battery pack or immerse the
battery pack in water. The wading of the whole
motorcycle should not exceed the center of the
wheel, otherwise it may cause water ingress in the
battery pack, internal short circuit and permanent
failure of the battery pack.
If water ingresses into the battery pack or battery
pack has other issues, it is strictly forbidden to
charge or use the battery pack. lt may cause fire,
burn and explosion of the battery pack.
The battery pack is water resistant and sealed
with a high voltage circuit inside. Damaged exter-
nal structure will reduce the water-resistant
performance of the battery pack. lf the water-re-
sistant structure is damaged, please contact the
after-sales service. lt is strictly forbidden for users
to disassemble the battery pack to avoid potentia
damage and serious danger.
Battery Pack
Starting and Operating Power Management
7.1 1
8 .1

Table of Contents

Related product manuals