The specific functions that can be set are (By
combining of pulls on the brake lever):
① Low regenerative braking. Operation: 2 short
and 1 long, indicator flashes twice;
② Medium regenerative braking. Operation: 3
short and 1 long, indicator flashes 3 times;
③ High regenerative braking. Operation: 4 short
and 1 long, indicator flashes 4 times;
④ Turn off the regenerative braking. Operation: 7
short and 1 long, indicator flashes 7 times;
⑤ Turn off the side stand switch and tilt switch.
Operation: 6 short and 1 long (automatically
turned on after vehicle powered on again),
indicator flashes 6 times;
⑥ Turn off the brake override. Operation: 8 short
and 1 long, indicator flashes 8 times;
⑦ Turn on the brake override. Operation: 9 short
and 1 long, indicator flashes 9 times;
⑧ Throttle sensitivity setting function. Factory
default is normal mode. Set to pro mode,
A. Rear Brake Lever
When you pull the lever backwards, it will control
the rear brake system.
B. Brake Lever Adjusting Screw
This adjusting screw is used to adjust the span
between the brake lever and the handlebar. The
position of the brake lever is adjusted by using a
2mm Hex wrench to make it more suitable for
individuals.
This is a two-position self-return switch located on
the right of the frame body. The functions are as
follows:
1. Lock A
2. Unlock B
Operating the Battery Compartment Lock:
1. When in lock position, insert the key into the
Battery Compartment Lock and turn counterclock-
wise to switch the key from lock position to unlock
position. When the key is in unlock position, the
battery compartment cover can be opened.
2. When releasing the key, the key will automati-
cally return from unlock position to lock position,
and the key can be removed when in lock position.
Starting
1. Turn the key switch to the ON position.
2. Confirm the battery level displayed on the
battery is sufficient.
3. After confirming that there are no obstacles and
passing vehicle in the surrounding area, retract
the side stand, twist throttle to increase speed and
start riding.
Braking
The brake levers are located on the left and right
of handlebars.
The right brake lever controls the front brake.
The left brake lever controls the rear brake.
Parking
1. Ensure the throttle is at idle position.
2. Put the side stand down in case of the motorcy-
cle tilt over.
3. Turn the key switch to the OFF position then
remove the key, and keep it safe.
Battery Compartment Lock
Motorcycle
Riding Light Bee Electric
Starting and Operating Starting and Operating
7. 5
7. 6
Gradually increase the braking force could
stop the Light Bee electric motorcycle
gently without locking the wheels. The
Light Bee electric motorcycle is a powerful
vehicle, so it is highly recommended that
you practice adequately and master all
the safe emergency stop operation.
WARNING
After each ride, please check the remain-
ing battery level and charge the battery
pack in time.
NOTE
A
B
To Next Page
Loading...
