1、Reorient or relocate the receiving antenna.
2、Increase the separation between the equip-
ment and receiver.
3、Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
4、Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifications not expressly
approved by the party responsible for compli-
ance could void the user's authority to operate
the equipment.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful interfer-
ence in a residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in accor-
dance with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not
occur in a particular installation. If this equip-
ment does cause harmful interference to radio or
television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
13.9 13.10
Annex Annex
Vehicle model
Dimension
Ground clearance
Seat height
Dry/Curb weight
Carrying capacity
Tire
Assistance functions
Wheel base
Front fork travel
Rear shock/wheel travel
Power system
Rated power
Maximum power
Maximum torque
Top speed
Range
Battery Type
Riding mode
Charge time
Frame design
QL4000DY-A
1850x780x1080mm
270mm
830mm
57kg
100kg
Front Off-road-70/100-19 Rear Off-road-3.00-18
Regenerative Braking (on SPORT mode)
1255mm
200mm
85/210mm
PMSM+FOC sinewave controller
4000w
8000W
266N.m
75km/h
75km（@40km/h）
Lithium battery 60V/40Ah
SPORTS + ECO mode
3h
Aluminum forged frame
PARAMETERS LIST
To Previous Page
Loading...
