Surron LIGHT BEE X - Power System Management; Power System

Power Management Power System Management
8.4
9 .1
If you find the following situations,
please stop charging and disconnect the
power supply immediately, and do not
use the electric motorcycle，Contact
Surron after-sales service or send to
maintenance point as soon as possible:
The battery pack housing is damaged;
Strange smell during charging;
The battery pack or charger overheated;
Smoke or fire in the battery pack. lf
occurs, throw the battery pack into water
immediately to avoid further losses.
SERIOUS WARNING
"Due to the continuous optimization of
the low power consumption protection
feature of the 2025 model Light Bee
battery pack, when the battery pack is
charged 6 or when the circuit breaker of
the vehicle is in the off position, it may
remain in a dormant protection state. To
initiate charging, it is necessary to
activate the battery pack by pressing the
button located next to the battery LCD
screen.
CAUTION
It is strictly prohibited for users to disassem-
ble the motor without permission, otherwise
it may cause the position sensor malfunc-
tion or damage the corresponding seal
which can lead to motor failure.
It is strictly prohibited to disassemble the
controller and its cables without permission,
it may cause serious consequences such as
electric shocks and burns. The controller is a
high-voltage precision electronic compo-
nent with cables carrying large current.
Incorrect wiring connection and wrong
screw torque may cause damage to the
controller or power system.
WARNING
The power system of Light Bee electric motorcycle
mainly consists of a motor and a controller.
Power System
The power system of the Light Bee electric
motorcycle must be repaired or replaced by
a trained professional technician authorized
by Surron. Users are not allowed to disas-
semble or modify the power system of the
Light Bee electric motorcycle. It's prohibited
to put the power system into the water,
otherwise it will cause damage.
Power cables have high current during
operation, do make sure the cables are
correctly and firmly connected, ensure that
the torque and tightness of cable fastening
bolts meet the requirements, and ensure
cable insulation also meets the require-
ments. Disassembling power system
components and cables is strictly prohibit-
ed.
WARNING