EasyManua.ls Logo

Surron LIGHT BEE X - Power Supply and Charging

Default Icon
51 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Always charge the battery pack in a
well-ventilated environment and keep away
from any combustibles. Do not charge in
rain.
WARNING
WARNING
The battery pack can only be charged with
the original charger or dedicated charger
specified bymanufacturer. The use of unau-
thorized chargers or accessories may cause
damage, failure of the battery pack or even
danger.
Do not charge the battery pack below 0℃
(32℉), otherwise it will damage the battery
pack. The battery pack can be charged
again after its temperature rises back above
0℃(32℉).The maximum allowable charging
temperature insidethe battery pack is 60
℃(140℉).
lf the internal temperature of the battery
pack exceeds this value, it can only be
charged after natural cooling below 55
℃(131℉). The battery pack will discharge
and heat up rapidly after heavy riding. Even
if the ambient temperature is low, the battery
pack internal temperature may still be high.
The battery pack is only allowed to naturally
stand and return to normal temperature. Do
not use other methods to rapidly raise or
lower the temperature of the battery
pack.The battery pack may not be able to be
charged immediately after high power
output or high temperature operation.
Charging should begin after the battery pack
has cooled for 30 minutes or more. The
battery management policy does not allow
charging when the internal temperature is
too high to protect battery life.
Power Management Power Management
8.2
8.3
Before charging, please check whether the grid
voltage is within the input voltage range support-
ed by the charger.
For USA and Japan: 100~120V AC,45~65Hz;
For Europe: 200~240V AC, 45~65Hz.
Before charging, please check whether the socket
load power of AC power network can meet the
power requirements of the charger (1000W or
more is recommended)
When charging, please connect the charger
output plug to the battery pack first, then connect
the charger input plugto the AC power supply.
Connect the charger output plug into the battery
charging port A on the left side of the motorcycle
to charge.
The charger will turn off automatically when the
battery pack is fully charged. Please disconnect
the power supply for the charger and the charging
plug connected to the battery.
Power Supply and Charging
When charging, please put the motorcycle /
battery pack in a safe place, beyond the
reach of children.
Avoid using the battery pack when it has
just finished charging. After fully charged,
disconnect the charger before use. it is
recommended to let it stand for 10 minutes
or more before use.
It is prohibited to cover any object on the
charger during charging. The charger is for
indoor use, please use it in a dry and
well-ventilated environment.
Please cover the charging port cap of the
battery pack after charging is completed.
CHARGING PRECAUTIONS
A

Table of Contents

Related product manuals