Surron LIGHT BEE X - Light Replacement; Motorcycle Cleaning

When adjusting the tension of the chain,
adjust the adjusting bolts on both sides
equally.
CAUTION
Maintenance Maintenance
10.13
10.14
Light Replacement Motorcycle Cleaning
A
B
A
B
C
Chain Adjustment Procedure
1. After removing the key from the key switch and
turning off the main power switch, prop up the
body of the motorcycle with a lift stand so that the
rear wheel is suspended.
2. Loosen the rear wheel axle nut C.
3. Loosen the locknut A of the left and right adjust-
ing bolts B.
4. Adjust the left and right adjusting bolts B equal-
ly until the chain is adjusted within the specified
range.
5. Tighten the rear axle nut C.
6. Tighten the left and right locknuts A to fix the
position of the adjusting bolt B.
7. Test ride the motorcycle.
8. After the test ride, please recheck whether the
chain is adjusted correctly, and re-adjust if neces-
sary.
1. Use a sponge or clean soft cloth, neutral deter-
gent and water to gently clean the motorcycle.
2. Be extremely careful when cleaning the
dashboard, it is easy to get scratched than other
parts of the motorcycle.
3. After cleaning, rinse the motorcycle thoroughly
with water to remove all detergent residues.
4. Dry the motorcycle with a soft dry towel.
5. After cleaning, please check the vehicle careful-
ly for anomalies.
When the headlight A/tail light B/ is damaged,
please contact the authorized dealer for a
complete replacement.